11/9/2022 0 Comments Godin bridge pins size replacement2) When you're using the Electric Jack, the mag signal is disconnected from the onboard Mag buffer, and the only things connected to the Mag signal are the 5-way switch, the Mag Tone control, the Mag Volume control and the Tip terminal of the output jack.īased upon that we discussed Active DI boxes. Here's what they stated.ġ) Please note that the Electric jack is a passive Mags jack, so make sure that the signal is going to a high-impedance input, typically upwards of 100K ohms and preferably around 1 Megohm. So, if you or anyone else has heard of this issue before, please chime in.Īnd I cannot figure out for the life of me why my posts are having such problems with the formatting.īoth Godin and Richard were quick to respond. I'm not sure when this volume issue came up, though, but it has been that way for a few months. I know they were normal volume when I received the guitar. But I really only noticed the tonal change this past Sunday, and that was because I had to change the battery in the xtSA. This has been going on for a little over a month. You can easily hear when it happens.almost like all bass has dropped out of the tone/EQ. Now, just when you think you've heard it all.Īgain, in that same config with or without the 13-pin, with the acoustic's volume up just enough that you can actually blend the acoustic & electric tones, when I turn the electric's volume to 8 the entire tone turns quite tin-ish (or brittle or thin) sounding. I had to turn the amp up to about 60% just to hear it till that 7 level kicks in. Running the same configuration as above (with or without the 13-pin connected), and only turning up the electric pups, there is the absolute minimum volume from them (in all 5 switch positions) UNTIL the volume knob is turned up to 7 (if it had 1-10 on it). Single cable out from ACOUSTIC/MIX direct to amp: Acoustic fine, electric low volume. Single cable out from ELECTRIC direct to amp: Low volume. These were my test today, along with results. Fact is, the POD has to be turned up to about 80%, and then you can turn the gain on the board down.but to no less than 50%. When running into POD it doesn't help much because the input level is so low. When running direct into board I've had to turn the gain up significantly more than any other input on the board, to 80% or more. Before I go into detail as to what's happening, let me tell you the setup from my xtSA.ĮLECTRIC 1/4" - Usually direct to board, sometimes into Line 6 POD.ġ3-pin to GR-55 with 1/4" stereo output to board.ġ3-pin GUITAR OUT usually to VoiceTone Correct. I read those 8 pages, and then at least 3 other threads that were linked in that thread. (Duh.acoustic isn't electric, Steve!) FYI, I did do a search on the board for "Godin low volume electric" which returned two results.neither of which applied here. Has anyone else experienced this issue? Is there maybe a hidden battery? I changed out the one for the acoustic side but it didn't help. This was so bad that two mins before Mass started I decided to ditch the xtSA and go with my trusty Dean acoustic/electric. On the board Sunday I had to max out the channel gain, and almost max out the volume fader. I can't get a balance of output between the acoustic and electric sides. It seems the volume, on all five pu positions, has dramatically decreased. I recently started having an issue with the electric side of my xtSA.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |